INFORMATION - DESCRIPTION
Pegs are usually mounted on one side, onto the wheel axle. Some pegs allow mounting from both sides; if that is possible, you will find it in the specification below. To mount a peg you need to replace the wheel axle with a longer one — determine the new axle length by measuring the length of the existing axle and adding the required extension according to the specification below. Some peg sets already include axles and adjustment washers (spacers to offset the peg), which can be used, but their length may not match your scooter and the axle may need to be purchased separately. Also pay attention to the shape of the deck/fork and the shape of the peg seat; some pegs have a wider taper at the start of the seat and may not fit into certain forks/decks, in which case you need to use spacers to offset them or choose a different peg shape. If you are unsure, contact our support or service.
Peg specifications:
Required axle extension: 15 mm
Outer diameter of peg: 32 mm
Inner diameter of peg: 27 mm
Peg length: 40 mm, 50 mm
Fits axle diameter: 8 mm (standard)
Can be used opposite each other (two pegs per wheel): Yes
Material: 4140 CR steel
Weight of pegs including axles: 182 g
Package contents:
Set of two pegs, two axles (lengths 60 mm and 85 mm).
Accessories:
Axles: https://www.scootering.cz/osy-kolecek-pro-freestyle-kolobezky/
